Author Topic: DIY Brake Pedal Repair  (Read 1505 times)

Joggernot

  • Pencil Stache
  • ****
  • Posts: 510
  • Age: 78
  • Location: Gulf Coast, TX
DIY Brake Pedal Repair
« on: July 28, 2015, 03:53:40 PM »
Last night our neighbor came over and said that our brake lights were still on on the Accord.  Went out and looked, and, yep, they were on.  Couldn't get them to turn off.  My wife looked up a video on how to fix the problem, while I looked on forums to find out how to fix the problem.  Between the two we learned that all it was was a broken plastic bushing on the brake pedal between the pedal and the brake light switch.  Because the stores were closed, we put a small pad of paper in place to hold the switch so the battery didn't drain all night.

This morning I went to our local auto store (O'Reilly's) and bought the replacement bushing for $8 (I had a printed photo of what I needed).  My wife then proceeded to put it in.  The video gave good info, but the forum people gave the tip on how to install it that turned the total job into a 30 second job.  I don't even want to think about what I'd been charged if I had gone to the dealer or even my mechanic.

kendallf

  • Handlebar Stache
  • *****
  • Posts: 1068
  • Age: 57
  • Location: Jacksonville, FL
Re: DIY Brake Pedal Repair
« Reply #1 on: July 28, 2015, 08:42:40 PM »
Nice!  It's amazing how simple some fixes can be, and what people will pay to avoid doing them personally.  :-)

HipGnosis

  • Handlebar Stache
  • *****
  • Posts: 1825
Re: DIY Brake Pedal Repair
« Reply #2 on: July 30, 2015, 09:27:37 AM »
What forum gave you the 30 second tip??

Joggernot

  • Pencil Stache
  • ****
  • Posts: 510
  • Age: 78
  • Location: Gulf Coast, TX
Re: DIY Brake Pedal Repair
« Reply #3 on: July 30, 2015, 11:13:51 AM »
I did a search and I think it was Toyota Nation Forum/Tacoma.  Here's the tip:  Don't try to put the small piece in place.  Just depress the brake pedal a little, slip the piece against the microswitch, and release the pedal.  The piece will self center and pop into place.  30 seconds includes getting down to look and doing the whole job that way.