Author Topic: Reattached my ridge vent.  (Read 856 times)

Gone Fishing

  • Magnum Stache
  • ******
  • Posts: 2925
  • So Close went fishing on April 1, 2016
    • Journal
Reattached my ridge vent.
« on: January 22, 2023, 08:49:05 AM »
Last week, high winds blew off two sections of our ridge vent.  We have a steep pitched roof, greater than 12/12 and impossible to walk on.  I’ve done a bit of wall and rock climbing a handful of times over the years, by no means am I a regular climber, but I do have a bit of gear, so I set up a rope, climbed up and reattached the ridge vent.  Turned out to be harder than I thought it would be, but I pressed on and got it done, with the help of my wife and son passing things up.   Two days later and my body still hurts.  Might never get up there again, but for a moment, I was a true badass. 
« Last Edit: January 22, 2023, 01:16:39 PM by Gone Fishing »

Dicey

  • Senior Mustachian
  • ********
  • Posts: 22384
  • Age: 66
  • Location: NorCal
Re: Reattached my ridge vent.
« Reply #1 on: January 22, 2023, 09:52:59 AM »
Good job!

BlueMR2

  • Handlebar Stache
  • *****
  • Posts: 2313
Re: Reattached my ridge vent.
« Reply #2 on: January 22, 2023, 12:06:26 PM »
It's amazing how tough it can be on a roof that doesn't even look to be steep!  I had a single pull loose up near the ridge vent a couple years back.  I could barely work up there as I kept starting to slide down!  From the ground, looks like nothing, but get up there and it's a different ballgame!  :D

Sibley

  • Walrus Stache
  • *******
  • Posts: 7449
  • Location: Northwest Indiana
Re: Reattached my ridge vent.
« Reply #3 on: January 22, 2023, 08:30:49 PM »
How does a ridge vent blow off? At least, without also pulling off a bunch of shingles?

Congrats on getting it back on. But I am still very confused how this happens.

sonofsven

  • Handlebar Stache
  • *****
  • Posts: 2052
Re: Reattached my ridge vent.
« Reply #4 on: January 23, 2023, 05:04:47 AM »
How does a ridge vent blow off? At least, without also pulling off a bunch of shingles?

Congrats on getting it back on. But I am still very confused how this happens.
Nails pulled out due to bad technique most likely. Ridge vent is installed over the top course of shingles on both sides of the roof.
It's really independent of the roof shingles, unlike a standard vent which is installed within the courses of roofing, with some shingles under and some over the vent.
Good job OP. Like many parts of construction, the work itself isn't that hard, but getting to the work can be. Be safe!

Gone Fishing

  • Magnum Stache
  • ******
  • Posts: 2925
  • So Close went fishing on April 1, 2016
    • Journal
Re: Reattached my ridge vent.
« Reply #5 on: January 23, 2023, 07:11:47 PM »
How does a ridge vent blow off? At least, without also pulling off a bunch of shingles?

Congrats on getting it back on. But I am still very confused how this happens.
Nails pulled out due to bad technique most likely. Ridge vent is installed over the top course of shingles on both sides of the roof.
It's really independent of the roof shingles, unlike a standard vent which is installed within the courses of roofing, with some shingles under and some over the vent.
Good job OP. Like many parts of construction, the work itself isn't that hard, but getting to the work can be. Be safe!

Yep.  1” nails that barely penetrated the underlying shingles.  I replaced them with roofing screws long enough for a good bite into the sheathing.

bacchi

  • Walrus Stache
  • *******
  • Posts: 7093
Re: Reattached my ridge vent.
« Reply #6 on: January 25, 2023, 01:46:10 PM »
One of these days I'll install S-5 anchors on my metal roof so that I can clip in with a harness.